If any door is open, machine will stop to protect operator. Machine Total Weight: approximately 3,000 KgĪll moving machine parts are covered by safety doors with safety switches.Labeling Product Type: Custom Square bottle.Label Type: OPP label film, paper-plastic film labels, paper labels.Custom label width (height): 110mm (standard width, the width may be increased according to the size of the actual product).Labeling Maximum Speed: 2,500 bottles/hour (according to actual production speed adjustment).Motor Speed: Stepless Speed adjustment motor control.Conveyor line speed: 30 m/min (speed of the conveyor line can be adjusted according to the actual situation of production).Device total length: 2,825mm (labeling machine belt length: 2,615mm client can be adjusted according to the actual size of the production line).This part is coated evenly and saving glue. The Adhesive roll uses labeling glue evenly coated on both ends In rubber roller way. Meanwhile, melt glue machine sol state to a desired temperature, Constant voltage (uniform). ◆coating and sol dryer –when working, coating mechanism pushed by the cylinder make the coating glue roll and labeling drum tangent fit. And This standard mechanism is stability. ◆Traction and drive – use the motor to drive the traction roller, pinch roller is connected by a threaded rubber traction roller compaction, through the label by the pinch roller intermediate rubber roller and traction, the control system controls the servo motor, to achieve the purpose that traction control of the label length. This mechanism durable mechanical part, when it is cut : small vibration, low noise, long life of blade. ◆Cutter and drive – use single-pole structure, by vacuum pump action, by the traction unit came labels adsorbed on the go at the cutter is cut, another part of the secondary air is blown follow the label, successfully separated from the cutter drum transferred to drum labeling. The free supply of bottled detection deviceĥ.12). The supply of the star wheel abnormal state termination device Control: motion controller, frequency converterĭriving part is provided with overload running protection device By the conveyor belt of containers by supply starwheel are properly arranged and adhesive label in roll of labeling for the first time, and then rely on the synchronous belt and the perfection of the labeling workĤ.1). After the label, the label enters the shearing part to carry on the cutting operation, and then the cut good label is sent to the vacuum sucker.ģ.6). Once the electronic eye position is confirmed, the demodulator automatically adjusts the operating speed of the standard wheel, and then correctly specifies the cutting position.ģ.5). When the label passes through the standard wheel, the sensor automatically detects I-MARKģ.4). Labels delivered from the label rolls are used for labeling operations along the guide rails along the guide rails.ģ.3). ![]() The labeling: straight line type hot melt labelingģ.2). Label specifications: refer to user requirements When the length of the trademark is changed, the automatic adjusting button can automatically adjust the position of the I-MARK. ![]() Made of special material of vacuum suction roller and the lower part of the trademark cutting wear anti feverġ.6). The position of the blade can be adjusted accurately and conveniently by the manual operation disk.ġ.5). Replacement of compatible parts can be done quickly and efficiently within 10 minutes.ġ.4). Vacuum suction mark wheel is made of high hardness material The added wrinkle treatment program can reduce the friction of the trademarks and prevent the static electricity generation.ġ.3). Trademark cutting blade adjustment easyġ.2).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |